Wayne PC1 Manuel d'utilisation et d'entretien télécharger pdf (Page 4)

Operating Instructions and Parts Manual

Troubleshooting Chart

www.waynepumps.com

Symptom Possible Cause(s) Corrective Action

Pump will not start or run 1. Blown fuse 1. If blown, replace with proper sized fuse or

reset breaker

2. Low line voltage 2. Voltage of power supply must match the

voltage of the pump

3. Worn brushes 3. Replace brushes (PC2 Only)

4. Impeller blocked 4. Remove blockage

5. Motor has overheated (Model PC2 only) 5. Disconnect from power supply and allow to

cool (Minimum 10 minutes)

Pump will not prime or

retain prime after operating

1. Air leak in suction line 1. Repair suction line by tightening inlet

connection or replace

2. Impeller blocked 2. Remove blockage

3. Worn seal 3. Replace seal

4. Suction lift too high 4. Lower pump

5. Hose kinked or looped 5. Straighten hose

6. Fittings not tight 6. Tighten fittings

7. Suction hose out of water 7. Submerge suction hose end

8. Clogged inlet 8. Clean inlet

Flow rate is too low 1. Inlet hose plugged or

kinked

1. Clean or replace

2. Low line voltage 2. Voltage of power supply must match the

voltage of the pump

Shaft seal leaks 1. Worn seal 1. Replace seal

2. Shaft grooved 2. Replace pump

3. Pump head loose on motor 3. Insure proper assembly and no obstruction,

tighten bolts

1 2 3 4 5 6 7 8

Pas de commentaire

Wayne PC1 Manuel d'utilisation et d'entretien Page 4