Wayne ESP45 Instructions d'exploitation télécharger pdf (Page 2)

Address parts correspondence to:

Wayne Water Systems

101 Production Drive

Harrison, OH 45030 U.S.A.

For Replacement Parts, call 1-800-237-0987

Please provide following information:

-Model number

-Serial number (if any)

-Part descriptions and number as shown in parts list

www.waynepumps.com

Ref. Part

No. Description Number Qty.

ESP45

1 Pump 06710 1

2 PS/BC (power supply/ battery charger) 30260-001 1

3 Impeller assembly 29884-001 1

4 Wear ring 28183-001 1

5 Impeller plate 15958 1

6 Seal 21203-001 1

*7 Float Kit, ESP45 60120-001 1

* Service Part Only

Battery Information

The system is designed to operate most

efficiently with sealed lead acid (SLA)

batteries. Deep cycle marine batteries

can also be used.

Sealed lead acid batteries cost slightly

more, but they can last longer. Wayne

offers a 40 amp hour battery WSB1240

and a 75 amp hour battery WSB1275.

The oversize battery case (included) will

accommodate two 12-volt SLA batteries

or two 12-volt deep cycle marine batteries

(up to a 27-frame size).

Retain blue foam pad to support Wayne

sealed lead-acid batteries. Use new,

identical batteries (from the same

manufacturer and of the same capacity).

When batteries wear out replace them as

a set. Chart 1 illustrates the expected

performance with various battery

combinations. Do not use batteries rated

below 40 amp hours.

Be certain that the area around the

batteries is well ventilated. Before

servicing the batteries, blow away

gasses by waving a piece of cardboard

near the batteries.

Dangerous

hydrogen gas can

be released from batteries while

charging. Sparks can ignite the gas in

an enclosed space. Wear safety goggles

when connecting batteries. Battery

connections should be made in a well-

ventilated area.

Working in the

vicinity of lead acid

batteries can be dangerous. Before

making connections or servicing the

batteries, read and follow instructions in

all applicable instruction manuals. To

reduce the risk of battery explosion,

follow the instructions in this manual

and those published by the battery

manufacturer, as well as those of any

other equipment used in the

surrounding area.

An assistant should be present or close

enough to come to your aid in the

event of an emergency. Have a reliable

source of fresh water and soap nearby

in case battery acid contacts clothing,

skin or eyes.

Wear eye and clothing protection when

working around lead acid batteries.

Avoid touching your eyes when

working around lead acid batteries.

If battery acid

contacts your

eye(s), flush with cold running water

for 10 minutes and seek immediate

medical attention. If acid contacts your

skin or clothing, wash immediately

with soap and water.

Never smoke or

allow a spark or

flame in the vicinity of the battery.

Avoid dropping

metal tools on the

battery posts because they may spark or

short-circuit the system or battery,

causing an explosion.

PS/BC Features

POWER CIRCUITS:

• Power Supply/Battery Charger (PS/BC)

monitors power availability and

automatically switches to battery

operation during power outage.

• Charger will run pump motor or charge

batteries when plugged into AC power

• Automatically charges the batteries

• Operates on 120 VAC and 24 VDC

(Using 2 batteries)

• The PS/BC can be left connected to

the batteries indefinitely

• The PS/BC is designed for the Wayne

Water Systems pump only, DO NOT

Use For Any Other Purpose

Operating Instructions and Parts Manual

SYSTEM WILL ALARM IF:

• You will hear a beeping alarm if

pump motor is running

• You will hear a continuous alarm if the

pump fuse on front panel is blown

• You will hear a continuous alarm if

the battery voltage drops below 21.6

NOTE: The alarm must be on for the

mute function to activate.

LIGHTS:

• Green Light indicates AC power is

available

• Yellow Light indicates battery is

connected correctly

• Red Light is on when battery voltage

is low or if the pump motor fuse on

the front panel is blown

PUMP:

• The pump will turn on when the

float switch rises. The pump motor

will keep running for 15 seconds

after the float drops

www.waynepumps.com

12V

Battery

12V

Battery

Jumper Wire

(Black)

Negative

Battery Cable

Figure 1 - Battery connection: two 12-volt batteries equals a 24-volt battery

PS/BC

(Red)

Positive Battery Cable

Amp Hours Total Gallons

Per Battery Pumped*

40.0 11,000

80.0 22,000

120.0 33,000

* Assumes the sump pump is lifting water 10’

CHART 1 - STANDBY POWER

PUMPING CAPACITY

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Wayne ESP45 Instructions d'exploitation Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes à eau Wayne ESP45